How Do I Change an Apple iPod Battery A1199?

The Apple ipod A1199 battery is the alternative battery for the ipod Nano 2G (2nd generation). The ipod Nano 2G is an MP3 player, identified very best for its scaled-down dimensions. As opposed to its predecessors, the ipod Nano 2G also arrives in a assortment of shades. You can get the ipod to the nearest Apple retailer and have them change the battery for you, but if you do it oneself, you are going to preserve a good deal of income.

Points You are going to Want

Tiny flat-head screwdriver Soldering iron Alternative battery

Pop the best of the ipod Nano off by wedging a Tiny, flat-head screwdriver beneath it. It is linked with adhesive, so you will have to function at it a Tiny bit. Repeat this stage with the bottom.

Unscrew the Tiny screws on the best of the ipod and Put them aside. Eliminate the screws from the bottom side of the ipod and Place them aside also.

Wedge your Modest, flat-head screwdriver beneath the headphone jack and gradually pry it upward. It ought to come straight up, but do not get it all the way out of the ipod. There is a ribbon that connects these two items. Be cautious not to rip it. Lift the headphone jack as far out as it will go (it really should nonetheless be related to the ipod by way of the ribbon).

Stick your screwdriver into the ipod, along the duration of the ribbon and then press upward. You need to really feel the connector within of the ipod pop out, letting you know that It can be been unlatched.

Pry off the metal bracket that surrounds the cost port. Take away it totally and Put it aside.

Get rid of the screw that is situated in the hole exactly where the headphone jack was.

Press on the bottom of the ipod and push the primary board (the display, tough drive and battery) out via the top rated. Take away the major board fully from its casing.

Flip the principal board so that the battery is uncovered. Find the 3 Modest wires that are soldered to the circuit board. De-solder the wires and Get rid of the battery.

Place the new battery in the old battery's Set and solder its wires to the circuit board. Put the major board back again into its casing and change all the screws.