The 2nd generation (2G) 4-gigabyte (4GB) ipod nano was launched in 2006 and is a smaller sized, smaller edition of the traditional ipod. Simply because of its diminutive size the 2G nano is even much more susceptible to harm than other other ipod designs. Even dropping your nano as soon as or twice can outcome in long term injury. The great news is that if you have discovered your self with a damaged ipod you can disassemble it oneself in purchase to substitute components.
Issues You will Require
- ipod nano Situation opener device Small Phillips screwdriver
Insert the suggestion of your Scenario opener device (obtainable from any electronics retailer) in the seam among your ipod nano and the thin rectangular cover that sits on best of it. Perform your way along the facet of this top rated cover until finally it pops off.
Flip the tool over and repeat the method to get rid of the bottom cover from the Nano. Then use your small Phillips screwdriver to take away the two screws on the bottom of the tool around the headphone jack.
Insert the suggestion of your screwdriver just below the headphone jack assembly and gently pry it up. Be mindful not to entirely get rid of it as there are nevertheless wires related to it. When the jack is out of spot it will expose a single screw beneath.
Use your screwdriver to eliminate the single screw underneath the headphone jack. Then use the suggestion of your screwdriver to pop the thin metal frame out from the bottom of the nano.
Flip the nano proper-facet up and eliminate the two screws from possibly stop of the thin metal frame on the best of the tool. Then insert the suggestion of your finger in the bottom of the nano and slide the motherboard and display screen assembly up and out of the housing. Set the housing aside.
Lift the LCD display screen up from the motherboard and use your fingers to unplug the thick connector ribbon from the bottom corner of the display. Set the display aside and your nano is fully disassembled.
No comments:
Post a Comment